Harmony remote not updating

Go back and add all of the ST switches to your Harmony hub as Home Control devices, then turn each corresponding one on when your activity starts and back off when it ends. Open the Harmony app on your phone (as far as I'm aware, the phone app is the only way to add/edit Home Control devices) If you have multiple hubs, connect to your target hub. It looks like there is a delay between harmony activating the activity and ST activating it again which in turn stops the activity. I really would like this to work so I can just use the remote to start my activities. So, when I use the harmony remote, the activity comes on momentarily and then turns off. I tried re-logging in, adding the activity again, even resetting the ST hub with no luck.

Aside from its official statement, Logitech hasn't responded further to the online outrage about the removal of local access.Here's the full statement: Logitech recently released a firmware update for Harmony hub-based remotes that addressed some security vulnerabilities brought to our attention by a third-party cyber security firm.Logitech takes our customers’ security seriously, and we work diligently to fix these kinds of issues as they’re discovered. We are aware that some customers using undocumented Harmony APIs for local home control were affected as a side-effect of our closing these vulnerabilities.Logitech plans to release an official firmware update with XMPP controls in January.Many users of Logitech's Harmony Hub smart home hub and remote were recently met with a nasty surprise.

Leave a Reply